Noland Adams What is the proper way to clean a 1959 corvette sealed air cleaner?
Perhaps each "white" was given a nickname so it wouldn't get accidently used on the wrong charlie and the chocolate factory broadway promo code vehicle.
Bruce Fuhrman I have a 1962 327/340hp corvette that I just purchased to be all original with 26k miles.
If your arms are not long enough, some sort of long shaft tool, with a hook or an "L" on the end (such as a upholstery tool) will help.The original seat foam was molded out of latex foam rubber which deteriorates when exposed to air over a period of time. .The original color may be found written in green crayon behind the cardboard trunk divider once the paint is scrapped away.My question is this: what is the correct overall length of the driveshaft?I suggest that you remove the steering wheel in order to gain better access to all of the disconnections of the instrument housing. .Install an extra ground wire behind the instrument panel up out of sight. thanks in advance for any thoughts charles From: Doug Prince, SoCal Chapter Advisor: The tachometer in your Corvette operates on a bunch of spinning magnets that register RPM.Then use sandpaper or a small brush to clean the frame where the number is located.Thanks Gary From: Larry Richter, Founding Treasurer, sacc Hi; The history on old cars is difficult if not impossible to find out, if you do not have the original documentation.
Good Luck, Noland Adams *Note from Doc Hollada, Website Editor: Don, hopefully you will click on to "Our Membership" and download the membership form, a pdf file. .That means the engine was built at Flint, but was never shipped to the.Since the car has the original tire size and I do not plan to spend my weekends at the drag strip, I do not believe that the chassis or rear end will be at risk.Email From: Noland Adams, Founding President of sacc: Gary, Im sure someone keeps records of the Route 66 tv show, and the Corvettes that were used on the show.Lay a piece of cardboard over the lower seat frame so you don't tear your shirt or your back on the seat track attachment screw sticking up out of the frame.Attached you can see the newest photo from my engine after painting it 1 week ago.Dave From: Larry Pearson, SoCal Chapter advisor: Dave: I still have the original pump from my first 1962, and it is configured exactly like the service replacement pump you received from Paragon. .I've seen this on other 62's from time to time.
Michigan Chapter sacc I have the emergency brake light on my 61 vette and it has stopped working. .